LOSI 8IGHT FRONT DRIVE SHAFT
#16
http://www.rctech.net/forum/nitro-of...-cvd-pins.html
BY far the best tool imo is the Knock off....but w/e everyone has there opinion.
BY far the best tool imo is the Knock off....but w/e everyone has there opinion.
#17
The Bonesaver is designed for 1/8 drive shafts. It holds a close tolerance for precise pin replacement. Locktite is not needed as the pins will not self eject.
Its also designed with safety in mind for the user.
Its also designed with safety in mind for the user.
#19
#20
Your pin fell out? Did you use the IDRC tool or something else?
#21
Tech Elite
iTrader: (12)
Improvement on the Front Center Diff Shaft:
The 8ight buggy has a high working angle and a small -weak CVD in front of the center diff. They seem to wear out and cause a little noise the looser they get.
I have a Mugen MBX5 that has a large robust CVD that can handle a much larger working angle without binding.
These parts work well without mod to the 8ight chassis or driveline.
mugen parts:
U-Joint Shaft: C0264
U-Joint Cup: C0266
Front/Rear Universal Drive Shaft: C0267 (comes in 2 per pack, Spare)
Pin fro U-Joint: C0265
----------------------------------------------------------------------
Similar for the 8T, the Mugen MBX6 Rear center shaft assemble could replace the front center shaft on the 8T.
U-Joint Shaft: E0227
U-Joint Cup: E0225
2.5x15.8 Pin
Very nice boots E0236
The 8ight buggy has a high working angle and a small -weak CVD in front of the center diff. They seem to wear out and cause a little noise the looser they get.
I have a Mugen MBX5 that has a large robust CVD that can handle a much larger working angle without binding.
These parts work well without mod to the 8ight chassis or driveline.
mugen parts:
U-Joint Shaft: C0264
U-Joint Cup: C0266
Front/Rear Universal Drive Shaft: C0267 (comes in 2 per pack, Spare)
Pin fro U-Joint: C0265
----------------------------------------------------------------------
Similar for the 8T, the Mugen MBX6 Rear center shaft assemble could replace the front center shaft on the 8T.
U-Joint Shaft: E0227
U-Joint Cup: E0225
2.5x15.8 Pin
Very nice boots E0236