HEAT

iTrader: (26)

I havent had good luck with clutch bell bearings , so can i get some help on how to shim my bell the correct way !

mugen flywheel
Dynamite Max-Life Aluminum Clutch Shoes
losi clutch bell
" setup if this helps "


Thanks for any help ...

jgtruggy

do you have the extended engine mount? If not, the chassi flexes a ton which will cause your front clutch bearing to go quickly. I use the kingheadz extended engine mount. Works good

Integra

iTrader: (8)

set the CB/Spur mesh SLOPPY....like almost to the point u 2nd guess urself....that solved my bearing issues...but then again i do have the KH ext motor mount...and both chassy braces....try the mesh...then go to the motor mount.