best pipe for a werks pro 7 port
#1
best pipe for a werks pro 7 port
Hey, i was wondering if any one knows the best pipe for a Werks pro 7 port motor. i have a jammin jp-3 and wondering if that pipe would work well enough or if i should pick up a better pipe....any advice will be greatly appreciated
Thanks Mike
Thanks Mike
#2
Sirio/Werks 2013
#3
werks 2013 thats all it flat rips
#8
Tech Elite
iTrader: (57)
I race in Dallas, Tx and the werks products are used by a lot of the club racers both novice and pro/expert level. I have seen just about every pipe combo out there with the B7 pro. The Jp3 will work well but the 2013 just hands down works the best. Also has a very unique sound to it, very aggressive and raspy.
#10
I heard that the werks pipes work awsome but don't last long because they were thin and weak, or was I told wrong? Also I heard that the JP-1 works really well with the b-7.
#12
Tech Elite
iTrader: (227)
WERKS 086 pipe!
Guys this is an old thread, but I wanted to pose a question regarding the 086 pipe and V conical header for the TL B7 Pro .21 I just put in my buggy. I have several pipes to choose from and currently have the 086 bolted on it but have yet try it out.
The general consensus seems to be centered around the 2013 for the WERKS .21 as it helps it out on the bottom but still gives you screaming top end. How would you compare the 086 to the 2013? Also, I have all the JP pipes except for the 4 so I have options there as well, the 2 screams on this motor! I really appreciate you guys chiming in on this old topic!
Chad
The general consensus seems to be centered around the 2013 for the WERKS .21 as it helps it out on the bottom but still gives you screaming top end. How would you compare the 086 to the 2013? Also, I have all the JP pipes except for the 4 so I have options there as well, the 2 screams on this motor! I really appreciate you guys chiming in on this old topic!
Chad