XXX-NT motor question
Is there any way I can put an SG style shaft with a slide carb motor in my XXX-NT?
Thanks! |
I have an AD2 and the kit comes with linkages for both slide and rotarty carbs. No sure about the SG shaft though. I would think it would be easier to just get a rotay/threaded enigne though.
|
Thanks for the answer!
Im asking this because I already have a old motor from my Serpent 710. I was hoping to put this one since its only for bashing. Pascal |
Anyone put an SG shaft on a XXX-NT?
|
I dont think its possible without getting a custom nut for the flywheel.
|
With enough machine work and ingenuity, you can do almost anything with an R/C car.
With that said, you cannot install an SG crank in a XXX-NT truck with off-the-shelf parts (that I know of). |
since the gt2 uses a sg shaft you might be able to use the flywheel nut from it. not sure, just a guess.
|
The flywheel nut isn't the problem, it's finding the right clutch bell and flywheel to line up with the XXX-NT drivetrain without too much chassis mods.
|
I showed up at the track the other day with xxx-nt, but needed a motor. One of the guys that runs a mst-1 had a novarossi with an sg shaft and a rotary carb, along with some kind of offset motor mounts and with a little shimming we awere able to line the motor up good enough to run 3 five minute qual. and finish second in the main. So it can be done.
|
what flywheel did you use?
|
Originally Posted by shady3031
(Post 3420731)
I showed up at the track the other day with xxx-nt, but needed a motor. One of the guys that runs a mst-1 had a novarossi with an sg shaft and a rotary carb, along with some kind of offset motor mounts and with a little shimming we awere able to line the motor up good enough to run 3 five minute qual. and finish second in the main. So it can be done.
Did you use the MST-1 flywheel and clutch? |
Originally Posted by Rookie01
(Post 3422772)
Did you use the MST-1 flywheel and clutch?
|
Thank you very much! I will give this a try.
Pascal |
All times are GMT -7. It is currently 06:28 AM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.