Hyper 7 PBS front assembly question
Hi all,
I am rebuild my Hyper 7 PBS, and i have a question about how fear in should I thread 19106 (BALL & SCREW both 35 and 41 mm) into the upper and lower arms? Here is an image of what i am looking at. http://i206.photobucket.com/albums/b...bsthreadin.jpg Thanks for your time and help. Nick |
for the top pivot ball leave it out a 1/4th from knuckle... for the bottom screw it in till you dont see any thread....
|
Originally Posted by MADMAN23
(Post 3367794)
for the top pivot ball leave it out a 1/4th from knuckle... for the bottom screw it in till you dont see any thread....
Thanks for your help. I have had this question on OFNA website for a week without reply. Thank again. |
screw it in until it doesnt screw in anymore and then set your camber
|
Originally Posted by Nickmind
(Post 3370674)
knuckle is the flat unthreaded part of the screw?
Thanks for your help. I have had this question on OFNA website for a week without reply. Thank again. |
Originally Posted by MADMAN23
(Post 3371204)
should have posted it sooner ..:lol: i have a hyper 7 pbs pro buggy.... ... np;)
Thanks, |
madman23 would you be willing to email me your setup?
[email protected] |
Originally Posted by Nickmind
(Post 3374185)
Just to clarify that the knuckle is the flat unthreaded part of the screw?
Thanks, |
Originally Posted by nik77356
(Post 3374581)
madman23 would you be willing to email me your setup?
[email protected] e-mail sent . hope that help's . |
All times are GMT -7. It is currently 04:24 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.