SMC 2S 6000'S IN FLUX - PROBLEM!

[vstrok]

All - I purchased 2 of these guys for my Flux about 2 or 3 months ago. I only have about 10 runs on them. I used the batteries last Sunday, and charged them up 70% right after. A few days later I noticed the packs had expanded about 5 mm or so. Is this safe? I have heard of SMC having some "cell issues". I contacted Danny of SMC via this forum but have not heard back. What should I do? This sucks!

Thanks

[BashemSmashem]

So you are saying BOTH packs have puffed a little ? Monitor them and make sure they dont burst and wait too see what SMC says ..... They shouldnt have puffed up like that if they were not over charged/dis charged ..

[The Pope NJ]

Call them up I have spoke with them a few times and they are always helpfull.

[Bryan@SMC]

vstrok,

I'm sorry Danny hasn't replied to your post. He is very busy and unfortunately can't be on here as often, nor can I. Please call me tomorrow @ 540-298-7706. We will try to get your problem resolved asap. Thanks for your patience!

Bryan

[Freezebyte]

I had some issues with my original set as well, but probably my fault now that I look back at it. Got some brand new updated cells for half cost. Contact SMC and they will help you out, they are awesome down there!

[OG RC 10T]

Glad to see Bryan chimed in, its hard to get a hold of danny on the board. I had the same pack, with the same problem.

SMC took care if it, so dont worry, they are a good company.

[vstrok]

Originally Posted by OG RC 10T

Glad to see Bryan chimed in, its hard to get a hold of danny on the board. I had the same pack, with the same problem.

SMC took care if it, so dont worry, they are a good company.

Yessir! Talked to Bryan yesterday, and problem is resolved!!

[cyclone x]

so how do u go about getting them replaced or whatever because i have a lipo that did the same

[Duster_360]

Your 1st step is to call them and see what they want you to do....see reply #4 posted above.