MN Carpet Oval Racing @ MMR Direct
#1
MN Carpet Oval Racing @ MMR Direct
Popular Classes are:
Legends
Slash Mods
21.5 Rubber Tire Pan Car
17.5 Foam Tire Pan Car
--------------------------------------------------------------------
Updated 8/23/18
-General Club Rules-
--All classes unless noted differently may not be lower than 4mm (chassis and body).
--Max battery voltage for 1 cell should be no more than 4.22 volts. 2 cell may not exceed 8.44 volts.
--The use of reverse is prohibited during racing. If your ESC is capable, please disable or just don’t use it.
--Please have roof and door #s on your cars. As well as sponsor logos and such. These are race cars and should be presented that way. All classes are run subject to race day interest.
--We must try and meet minimum car count requirements and decisions will be made on race day whether or not we can run a class with few entries. We will try our best to fit you in if time permits.
-Legends-
Chassis- Only Bolink or RJ Speed Legends kits allowed. Only modifications allowed will be: You may use turnbuckle style steering to replace the wire rods. And the chassis may be drilled to securely mount the steering servo and/or battery ONLY. Bushings or bearings allowed.
Tires- Any foam tire allowed or CRC RT1 rubber tires also allowed.
Battery- Any 1-2 cell hard cased Lipo or 4-6cell Nihm/Nicd
Motor- Any brushed motor
ESC- Any non-adjustable brushed speedo. (cannot use reverse while racing)Body- Bolink/RJ Speed Legends bodies only
Roll Out (gearing)- Open. Stock size spur gear must be used. 81 tooth 48 pitch.
Breakout- 5.8 sec per lap. Any laps under 5.8 will not be counted.
-Slash Mods-
-Chassis/Suspension- Stock 2wd Traxxas Slash only. NO modifications. NO aftermarket or LCG chassis allowed. Stock Traxxas Slash shocks only (no limiting internally or externally) and unaltered Traxxas white progressive rate springs only (no cutting). No limiting of the shocks internally or externally means no foreign substances allowed inside your shocks (i.e. Vaseline, diff grease, fuel tubing). Traxxas pistons, hardware and R/C available shock oil only. All shocks must be functioning with no limitations. Suspension parts must be in stock locations and configuration (right on right, left on left) No aftermarket chassis or suspension parts allowed except the following:
-RPM suspension arms, axle carriers, steering blocks, or bumpers
No aluminum aftermarket parts allowed. Any added weight may only be added inside the top of the main chassis.
Tires- Stock Traxxas Slash tires and wheels only. No grinding of tires. Must have tread remaining across the entire face of the tire.
Battery- Any 2s hard cased lipo. No shorty packs.
Motor/ESC- Stock Traxxas 12t Titan brushed motor with any brushed ESC. Reverse cannot be used.
Body- Midwest Dirt Modified (i.e. AFX, Sippel, Barts, Custom Works) Please round all edges of the body. SC truck body allowed for one event only.
Ride Height- A min ride height may be added. No chassis or body parts may touch the track at any time.
Gearing- Open
Breakout- 5.5 sec per lap. Any laps under 5.5 will not be counted.
-21.5 RTC-
Chassis- Any 1/10th scale pan chassis
Tires- CRC RT1 Rubber Tires
Battery- Any hard case 1 cell lipo
Motor- Trinity TOUR Equalizer 21.5
ESC- Any ROAR “blinky” approved ESC (must be in “non-timing” mode at all times)
Body- Protoform RTC body or - McAllister Xfinity298, 299, Gen6F293, Gen6SS294
Weight- 36oz min
Ride Height- 4mm min
Roll Out (gearing)- Open
-Xfinity 17.5-
Chassis- Any 1/10th scale pan chassis
Tires- Any brand WGT tire
Battery- Any hard case 1 cell lipo
Motor- Any ROAR Approved 17.5 (Including TOUR Fantom 17.5)
ESC- Any ROAR “blinky” approved ESC (must be in “non-timing” mode at all times)
Body- Any Gen-3 or- McAllister Xfinity298, 299, Gen6F293, Gen6SS294
Weight- 34oz min
Ride Height- 4mm min
Roll Out (gearing)- Open
-Street Stock-
Chassis- Any 2wd off road buggy
Suspension- Stock length buggy shocks for both front and rear. Buggy springs.Tires- Any 2.2" or larger wheel with rubber buggy tire (non-aggressive tread). No CustomWorks Street Tracs or Sticker type tire.
Battery- 2 cell hard caseMotor- 17.5 max
ESC- Any ROAR “blinky” approved ESC (must be in “non-timing” mode at all times)
Body- McCallister Street Stock bodies only.
Ride Height- 20mm min
-----------------------------------------------------------------------
Follow us on facebook: https://www.facebook.com/mncarpetoval
Link to old RC Tech thread: http://www.rctech.net/forum/minnesot...al-racing.html
Last edited by fig865; 02-26-2019 at 08:40 AM.
#2
Tech Addict
iTrader: (21)
good job red!!!! I 'm working on the oval cars as we speak.. Got the sk fixed and looked over.. working on the legend right now.. And will start working on the spec truck asap.. Looking forward to some oval racing this year.
Last edited by racerj79; 05-29-2013 at 07:21 PM.
#3
#7
#12
SK is ready to go 13.5 is ready just need to get the body from jason when he gets it done I dont think I'll be there friday but I plan on being there next tuesday
#13