R/C Tech Forums - View Profile: Sambo 7

Go Back  R/C Tech Forums > Members List
Reload this Page >

Sambo 7's Profile

Sambo 7 Sambo 7 is offline

Tech Rookie

About Me

  • About Sambo 7
    Location
    QLD Australia

Statistics

Total Posts
Albums
Visitor Messages
General Information
  • Last Activity: 11-14-2012 02:35 PM
  • Join Date: 11-09-2012
  • Referrals: 0

Visitor Messages

Showing Visitor Messages 1 to 1 of 1
  1. Geezatec
    11-10-2012 09:21 PM - permalink
    Carb slide or rotary?? Rotary Set HSN to bottom out then 2 1/2 turns CCW. Idle speed or airgap 1.5mm. Prime engine with fuel by disconnecting fuel line from muffler, and blow into it, watching the fuel line tank to carb fills up with fuel. It starts, turn your idle down maybe started in hi rpm. Let me know!! I'm not in australia. This is close to manufacture settings for start up with Rotary carb.

    With Slide carb all the same except the airgap set at 1mm. HSN set at 3 turn from closing.

    Give it throttle it stalls turn HSN 1/16 turn CW until it stay running.

    Good luck!!!

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.