R/C Tech Forums - View Profile: Jam-Air

Go Back  R/C Tech Forums > Members List
Reload this Page >

Jam-Air's Profile

Jam-Air Jam-Air is offline

Tech Adept

About Me

  • About Jam-Air
    Biography
    Facebook.com/jamairmotorsports
    Location
    Chino, CA
    Interests
    Drag Racing & RC Racing
    Occupation
    HVAC Engineer
  • Signature
    Will Martin

Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: 08-17-2015 09:10 PM
  • Join Date: 01-02-2013
  • Referrals: 0

Visitor Messages

Showing Visitor Messages 1 to 3 of 3
  1. 09-26-2014 02:53 PM - permalink
    Very interested in the B5M roller. It looks pretty new (Clean), is there a lot of runs on it ?

    Anyway you would take $300 shipped to Oklahoma ?
  2. 07-25-2013 07:03 PM - permalink
    Hi Travis

    I didn't weight them. I put them on for looks and to be different

    My car also has the pr ti ball stud kit on it

    I will weigh my car and let you know the weight

    I know what Andrews weigh so we can figure it out that way

    In case your wondering those are the 1 3/8 length 3mm turn buckles from Lu sword.
  3. 07-25-2013 05:14 PM - permalink
    Will,
    I see you put what looks like lunsford TI turnbuckles on your PRS1. I was contemplating doing the same...but the stock buckles are small compaired to regular buggies. Did you weight lunsfords before install? Just want to know how much weight savings vs cost. I am going to run my buggy in stock so weight is always on the brain.

    Thanks,
    Travis

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.