dave-man
Tech Regular
Last Activity: 04-23-2024 01:17 PM
User Lists
121 Likes
-
dave-man liked post by glennhl On thread : USGTAll these classes are why 30 people can show up and there are 10 classes and it takes all day to run.Liked On: 07-16-2023, 07:17 AM
Posted On: 07-13-2023, 04:58 PMdave-man liked post by staiguy On thread : Slipper eliminator on carpetThanks for the advice! Today I hit up the track with the back up car and harpoon tires and :nod: . It all clicked after a few laps and adjustments. I'm still very newb but I was keep pace with the...Liked On: 07-06-2023, 09:45 AM
Posted On: 07-03-2023, 09:15 PMdave-man liked post by Marcos.J On thread : USGTall that motor tuning advantage just to lose it all when they smack the pipe on turn 2Liked On: 07-06-2023, 09:09 AM
Posted On: 07-03-2023, 04:59 PMdave-man liked post by STLNLST On thread : USGTOMG….I’m surprised racing made it this far after all this high school bickering🤣🤣🤣🤣🤣🤣Liked On: 07-06-2023, 09:07 AM
Posted On: 07-02-2023, 09:09 PMdave-man liked post by robk On thread : USGTThis is a motor that is even more tightly regulated than other "spec" motors. A Roar 21.5 motor is a spec motor. The idea is to buy it and race it. Not to send it to "Stator Stu" to get it...Liked On: 07-06-2023, 08:53 AM
Posted On: 06-29-2023, 01:32 PMdave-man liked post by Raman On thread : USGTJust use the damn screws that come with the motor.Liked On: 07-06-2023, 08:53 AM
Posted On: 06-29-2023, 12:10 PMdave-man liked post by Rick Worth On thread : Sky RC BD250 softwareThanks Dave-man. Picked up a Micro data/sync cable this morning and it works fine. I found out that most USB micro cables have 2 wires (+, -) for charging only. For data (sync) transfer you need a...Liked On: 03-29-2022, 07:48 PM
Posted On: 03-02-2022, 11:46 AMdave-man liked post by Marcos.J On thread : DIY lipo lithium heater / warmer bagisnt charging at 30-40 amps also illegal in ROAR?Liked On: 11-03-2020, 09:39 AM
Posted On: 10-18-2020, 03:22 PMdave-man liked post by DARKSIDE On thread : U.S. Vintage Trans-Am Racing Part 2https://www.facebook.com/USVTASouthernNationals/ get ready for the "ONE NOT TO MISS!!"signup will be open August 1st 12pm.... remember 1st one to sign up and pay will get a FREE entry to the...Liked On: 07-27-2020, 09:00 AM
Posted On: 07-23-2020, 07:45 AMdave-man liked post by sugs On thread : 17.5 tips and tricksTotally agree, and time to go back to the way it used to be with A thru Z mains. At my local off road track there is now mod, 21.5 and 17.5 2wd buggy, along with a separation of sportsman and...Liked On: 02-26-2020, 10:53 AM
Posted On: 02-26-2020, 07:26 AMdave-man liked post by Anthony.L On thread : 21.5 blinky stock buggy racing17.5 at our local small (75x40) indoor carpet track is only a couple tenths off mod motors. There are lots of tracks across the states that are moving from 17.5 blinky to 21.5 blinky to slow down the...Liked On: 01-27-2020, 07:58 AM
Posted On: 01-26-2020, 06:18 PMdave-man liked post by DesertRat On thread : What’s the worst part of building rc ???Ball diff, because you WILL be taking that thing apart again in the near future, no matter what, its not a piece that lasts.Liked On: 01-17-2020, 11:07 AM
Posted On: 01-16-2020, 05:58 PMdave-man liked post by gigaplex On thread : Bad driving vs bad set up, beginner questionsGet an experienced driver to drive your car. They can tell you if it's behaving correctly. If it is, don't try to tune it. Just learn to drive it. Also ask someone to watch you drive to give you...Liked On: 12-24-2019, 10:47 AM
Posted On: 12-23-2019, 03:47 AMdave-man liked post by Sir 51D3WAYS On thread : Front Toe QuestionVernier calipers to make sure the tie rods are both equal length. Then be VERY CAREFUL to adjust the linkages evenly on both sides when I want to adjust. E.g. 1/2 turn on the left, then 1/2 turn on...Liked On: 12-16-2019, 06:47 AM
Posted On: 12-12-2019, 04:06 PMdave-man liked post by TheRulesLawyer On thread : Does a $50 17.5 turn motor the same power as a $300 motor?A high end motor will have been assembled and balanced to the limit of the spec. Tighter tolerances cost money. There is always a chance you'll get that magic $50 motor that all the tolerance fell...Liked On: 12-12-2019, 07:25 AM
Posted On: 12-10-2019, 10:36 AM- Join Date
- 07-28-2010
- Total Posts
- 459
- Likes Received
- 137
- Likes Given
- 121
- iTrader
- Click Here
You have not created any albumsThe last 10 visitor(s) to this page were:This page has had 2,590 visitsContact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.