Nexus Race Track
#16
What exit do I have to get off on I-75 this sunday? and what time does the race start? I need to have an idea. That way I can figure out how late I can party saturday night
#17
Take the Delk Rd exit (#261?). Racing starts @ 1PM.
In case you want some brownie points, track set-up is a little before 10AM .
In case you want some brownie points, track set-up is a little before 10AM .
#18
another good way of explaining where it is
the exit when ur going to dave and busters
the exit when ur going to dave and busters
#23
Dane - Majority of the racers have made the switch to brushless. There might be a few guys still running brushed on Sunday.
K_Spec_RC - What parts do you need to race?
K_Spec_RC - What parts do you need to race?
#24
chea brushed for me tomorrow. maybe the glitching gods will spare me for a day of racing..............new receiver may help quite a bit i hope. see yaw there!
#25
#26
anyone have any extra 4x8 bearings? thats what bro is needing.
#28
The bearing and top deck screw shouldn't be a problem. The bearing holder for the layshaft bearing will be the tricky one. Have you tried any local shops to see if they have the part?
What happened to the original bearing holder?
What happened to the original bearing holder?
#29
Tech Elite
iTrader: (8)
I still have the holder, and it should be fine for tomorrow... its a little torn up, but should hold the bearing fine. I managed to find some spare screws left over from the build so thats all taken care of. so its just the bearing now. and if the one you have will work I will be a happy man
Also, I tried hobbytown but they are not carrying anything for the TC5 as of yet (and I doubt they will) I tried ordering them from Tower, but the "pay later" option failed so they did not ship my parts...
Also, I tried hobbytown but they are not carrying anything for the TC5 as of yet (and I doubt they will) I tried ordering them from Tower, but the "pay later" option failed so they did not ship my parts...
Last edited by K_Spec_RC; 08-04-2007 at 10:51 AM.
#30
The 4x8mm bearings I have should work on the layshaft of the TC5. They are the same bearings that the Cyclone uses on the layshaft assembly.