Micro Rolling problem???
I just finished my micro. It doesn't roll freely and I can't figure out why. I have a ball dif in the rear and a one-way in the front. and Steel Universals up front. All are HPI. I also put in Alum Steering Knuckles from Top cuz I seen so many people Break the plastic ones. I'm using Pro-match 6 cells packs and an HPI mod motor witha Hitec HS-81 MG Micro Servo. It runs fine other than the rolling issue. Which is killing my run time and performance. The only thing I noticed is the wheel hubs rub the inside so I demeled them out and rolls better now any one else have these problems. aor anything else that caused this nasty binding please help. Thanks, Rob