McFactory Motorsports
#62
I can't wait to try it. Thank you.
#65
Tech Master
iTrader: (17)
Thanks, just so people know what to expect - I started the race on stock carbon and the car was really good, had some issues with it wanting to double steer on the high bite and not stay quite as flat in the corner. Put on the new McFactory chassis and the car got a lot more linear and easy to drive. It didn't want to over rotate anymore and it also stayed flatter in the corner. All in all it was an easier to drive car.
#66
2 more added to the list in 17.5T
McFactory aluminum chassis dominate the 12th scale classes in the Mile High Indoor Championships at 5280 Raceway in Denver CO!
17.5 12th Scale:
1st - Joe Trandell (TQ)
3rd - John Wiita
4th - Kevin VanErt
Mod 12th Scale:
1st - Keven Hebert (TQ)
2nd - Corey Harbke
13.5 12th Scale:
2nd - Joe Trandell
3rd - Kevin VanErt
Congrats drivers!
17.5 12th Scale:
1st - Joe Trandell (TQ)
3rd - John Wiita
4th - Kevin VanErt
Mod 12th Scale:
1st - Keven Hebert (TQ)
2nd - Corey Harbke
13.5 12th Scale:
2nd - Joe Trandell
3rd - Kevin VanErt
Congrats drivers!
#68
Tech Master
iTrader: (6)
On the plus side - back to easy ride height adjustments with the older style slide-in CRC shims. That's a big plus.
On the down side - one significant benefit of a u-plate is that it does use the molded bosses on the bottom of each front arm to lock it in perfect alignment, rather than relying on the taper of the flat head screws to keep the arm from getting pounded back and slightly out of alignment. IMO, much more plus than minus.
On the down side - one significant benefit of a u-plate is that it does use the molded bosses on the bottom of each front arm to lock it in perfect alignment, rather than relying on the taper of the flat head screws to keep the arm from getting pounded back and slightly out of alignment. IMO, much more plus than minus.
#70
Congrats on the great results mike. Thanks for everything, it's much appreciated.
#71
where are prices listed? i've looked on the McF website, FB page and apexrc (which i didnt even see the chassis listed) and i see nothing. anyone care to shed light on this?
#72
#73
OHHHH!!. I wasnt aware that Apex was McF. Thanks a ton
#74