M.J

iTrader: (3)

Hello,

I bouirght one of these comm pens with the fibregalss tip. Wasnt really any instructions so i have a few questions.

Is it really as dangerous as it is writen over the pen should i be super careful?
How is the best way to use it? (I had a small go and it didnt seem to do much).

All Help greatly appreciated.

Cheers

Matt

Hyper1

Generally I use mine to just take off the glaze on my brushes inbetween runs then just reseat the brushes at 2 volts for about a min or so.You can put a piece of tape around the brissles a little ways down to keep the tip from spreading out to much,mine is in a little plastic holder that screws on and out so I don't really need the tape.

chach

Justwatch out for the fiberglass strands. Thats why you should put tape all the way around so you dont get a nasty sliver.

burbs

iTrader: (1)

I dont use tape it never seems to stick very long with the motor sprays and such.. i found the thinnest shrink tubing i could find and used that..

Brian Anthony

iTrader: (9)

If you want to save a ton of money go to Walmart and look in the Auto section with the touch up paints and there should be a 3M Nic Sander. Same exact thing as the Trinity item and it comes with I think 3 refills and sells for 2.99 or there abouts.

Hyper1

Exactly!!! That's where I got mine,but at the Big K,I refuse to shop at Wal-Mart.

dakrat

ok paris

Hyper1

?????

burbs

iTrader: (1)

i get my refils from a local antique shop.. there about 50 cents each .. they say they use them to clean the antiques.. either way its cheap..

Hyper1

The Wal-Mart thing is for another forum,just had to say it.