DeanGallegos

I just recently purchased a Sakura d3 for drift use. I've been having a problem I can't figure out, during use the pins that hold the universal joints on my front drive shafts are popping out during use. I've put them back in multiple times but can't think of a way to stop the pins from coming out again since it's a part that moves in a tight space.
Thanks,
Dean

DeanGallegos

Bump

WagwanBumba

iTrader: (1)

Check the manual

I think in the D3's case there's a small grub screw you screw in to the CVD joint to hold the pin in place.

multi-bash

iTrader: (9)

Could try putting a small piece of fuel tubing/silicone tubing/ciggaretter filter/cotton ball into the output cup - it could be the shafts are a little short and then able to back out. This can also help with chatter at full lock.