Team Durango DETC410v2

You're on Page 8 of 9
Go to
  • Yes, it seems it got quite a bit cheaper over here. €249 now... used to be €349, I believe. Oh and Durango belongs to Hobbico, but the original designer (Gerd Strenge) is from Germany, I think.
  • humm to bad tower hobbies hasnt changed there priced
    hope team durango doesnt drop this chassis
    any word on aluminium chassis?
  • SGrubb has a DETC that has a prototype but no one makes a mass market aluminum chassis.
  • If u can find a alum chassis put it on its way better then the kit chassis. the one i have is a prototype its very good.
  • can the split Suspension Hangers be used on front and rear?
  • Quote: can the split Suspension Hangers be used on front and rear?
    Yes.
  • my car r now on ebay under team durango
  • Is there something wrong with this car? It seems to be almost a clone of the xray and is about 100 dollars cheaper, but not many seem to like it or talk about it much ??
  • $100 cheaper? More around $270 cheaper over here (it's available for 249€ while the Xray T4 2016 is 489€ at the same store.) A lot of car for very little money. It's even supposed to drive very well. Only the v1 was said to be a little fragile, but with the new plastics on the v2 plus maybe an xray hard bumper that should no longer be a real problem. No idea why so few people seem to use it. A friend of mine bought the v1 cheap when the v2 came out, but he has still not built it yet.
  • Quote: Is there something wrong with this car? It seems to be almost a clone of the xray and is about 100 dollars cheaper, but not many seem to like it or talk about it much ??
    It's a good car especially the V2. The problem is that TD is not actively developing the car and to my knowledge, has discontinued their driver program as well as possibly given up on TC all together. It's sad really, as the car has a ton of potential. Hobbyco is a big company and likely unwilling to support a class that isn't profitable like off-road. I will continue to run mine as long as parts are available.
  • The V2 car is good, the V1 has the "sloppy" ball cups issue but far as I can tell is the only issue with it along the lack of setup coordinated setup development which this thread can help overcome.
  • Do you still have these parts available?
  • Quote: A couple of teaser images of my new carbon bits for the DETC410
    I have designed both with or without the Transponder mounting tabs and will be track testing them at our next race outing.
    Are these still available?
  • Quote: Are these still available?
    I noticed that stock is temporary unavailable at towerhobbies. Is the new chassis v3 on its way out or is durango dropping touring cars?
  • Finally get to take mine to a real carpet track tomorrow.