Xray X1 - Formula One Car
#167
Tech Elite
iTrader: (9)
Exploded view of the X1.
Questions that have been asked about the X1:
Questions that have been asked about the X1:
- Will different front wings (i.e. Tamiya hard plastic wings) fit on the X1? Answer: Yes, the bolt pattern is the same.
- What size are the rear hex hubs? Answer: 14mm, same as Tamiya.
- Will the new PROTOform F1 bodies fit on the X1? Answer: Yes. Confirmed by EricP.
#168
Tech Champion
After seeing the pics on RedRC I see the car can use an in-line battery configuration which should help more scale bodies like the Tamiyas fit better. But I wonder if the wide links are going to fit under a Tamiya body using the optional side pods. I remember my Exotek chassis had issues with the links not fitting well under a narrow body. Other than that question the car looks fantastic!
#169
in my opinion...is a X12 with long chassis and f1 front end...and a Recycled T3 Shock
#170
#171
XRay themselves even say that (except the part about the shock)
#173
Tech Apprentice
#174
Pretty car, but the front wing is a joke. That piece won't last through a single club race. It looks like a complete afterthought.
#176
#177
Tech Champion
iTrader: (17)
It's the rigid hard plastic bumper under the lexan wing that's impressive. A couple of screw holes and some hard plastic wings of different styles to fit on or snap down over it. No more dragging end plates! Only wishful thinking. Of course a strip CF under the wing will do the trick too.
#178
-
Last edited by Luppi Stefano; 12-18-2014 at 04:04 AM.
#179
Tech Rookie
#180