Xray T4'14
#242
Alu steering posts!
Hi,
Where can I find shorter alu steering posts for my Xray T4?
I know CSO fits but where can I buy one?
Are there other brands that fit?
Thx for replying.
Where can I find shorter alu steering posts for my Xray T4?
I know CSO fits but where can I buy one?
Are there other brands that fit?
Thx for replying.
#245
Tech Adept
Just received my T4-14 and as this being my first tc I'm looking for input on a servo and speed controller. I'll most likely be running 17.5.
Thanks
Thanks
#247
Hey guys I'm relatively new to tc racing and just got a T4 '14 just have a couple of quick questions.
1. Is everyone using the stock bumper?
2. Do aluminium steering arms make any difference?
3. Does the carbon stiffener for the bumper make a difference?
Thanks in advanced
1. Is everyone using the stock bumper?
2. Do aluminium steering arms make any difference?
3. Does the carbon stiffener for the bumper make a difference?
Thanks in advanced
#248
Tech Elite
iTrader: (37)
No u want to make a front bumper from a harder foam block or but a RSD front hard front bumper . also either use a brace to support the top of the bumper (bump stop) or use a T3 front standoffs with T3 (thicker) bumper . if u don't use the bump stop u can potentially rip the front screws they the chassis..
Also no the aluminum steering parts r not any better . they only add a few grams in place of adding lead weights . I have ran plastic for 15months and haven't broke A SINGLE PART and have tossed this car out of the track many times .
Also no the aluminum steering parts r not any better . they only add a few grams in place of adding lead weights . I have ran plastic for 15months and haven't broke A SINGLE PART and have tossed this car out of the track many times .
#249
Tech Adept
#250
Tech Elite
iTrader: (93)
I just took the T3 hard bumper and cut it down to the same height as the T4 bumper using a serrated steak knife. I left it a little thick intentionally then hit it with a little air sander in the garage to clean it up. The side I cut looks as good as the factory finished side after sanding. I already had the T3 hard bumper lying around, otherwise I would have bought the RSD one which I have on my other car. Getting a relatively straight cut is fairly easy if you take your time and don't try to cut too deep in one shot.
#251
Tech Apprentice
#253
Hey guys I'm relatively new to tc racing and just got a T4 '14 just have a couple of quick questions.
1. Is everyone using the stock bumper?
2. Do aluminium steering arms make any difference?
3. Does the carbon stiffener for the bumper make a difference?
Thanks in advanced
1. Is everyone using the stock bumper?
2. Do aluminium steering arms make any difference?
3. Does the carbon stiffener for the bumper make a difference?
Thanks in advanced
2. They are supposed to help sharpen up the steering on asphalt, but Alex Hagberg said they made it slightly worse on carpet.
3. I assume you mean the graphite upper bumper brace. Yes, fit one!
#254
Ok Thanks for the advice jlfx car audio, Odin544 and skiddins .