micrors4guy

iTrader: (50)

I'm not sure where you see a hole but that is my car and there is not one. I am going to put a hole in the rear shock mount for one

JayBee

iTrader: (31)

Exactly.
I just built mine and there isn't a hole anywhere for a roll over antenna. Strange...or maybe I'm missing something.

dr_hfuhuhurr

iTrader: (95)

The circled bit isn't a hole for the rollover antenna?

That's not good.

Sixgears

iTrader: (32)

Any tips for building this? I am going to be doing so within the next week or two

micrors4guy

iTrader: (50)

Nope. That's where the al. Block for the chock screw goes in from the bottom

Tron

iTrader: (17)

Nothing that I can think of other than JayBee's tip about a 0.3mm shim under the pivot block. The build is very simple and the instructions really are great.

Easier build than the RM-01 I just built.

Max K's baseline setup for Super Stock and Mod can be found on Arn0's site:

http://www.petitrc.com/reglages/vbcr...nning_IIC2013/

Sixgears

iTrader: (32)

Nothing to ream/polish/deburr/file/sand (except for chassis obviously!)?

Tron

iTrader: (17)

I polished any surface that could create friction drag - but absolutely not necessary, just something I like to do.

JayBee

iTrader: (31)

Where has 'VBC Racing Shop' been; I haven't seen that rep on this thread in a while

OVA

iTrader: (86)

Arent you the back up ...

JayBee

iTrader: (31)

Not exactly

dr_hfuhuhurr

iTrader: (95)

VBC, if you are following this thread, please make a shock mount with a rollover antenna. Or anyone out there in the hop-up world, that would be acceptable as well. Please don't make us run without our rollover antennas.

RedBullFiXX

iTrader: (34)

Would the R5 shock mount bolt on
These cars do share an un-canny resemblence

haywood

iTrader: (49)

+1

S.Stew

iTrader: (13)

Dave Johnson has a photo on his facebook showing his lightning 12 and it's got quite a tall rollover antenna on it. Maybe he can explain...?