theproffesor

iTrader: (66)

I aint gonna b▲▲w anybody, but having those for my VTA and USGT cars would be awesome. That mush of a reduction in rotating mass is definately going to help coming out of those tight carpet corners. What are the axles made of? The one part looks like the VBC aluminum part, I am refering to the axle stud.

Roedor

Hello,

I have been testing and my car works really well with new tyre, but during the first battery of the tyre I see that I start to loose steering little by little, when I finish the heat I see that the rear tyre is nearly new but the front one is not so good, if i continue using the same tyres in the same possition this continue happend and I continue loosing steering, What should I change in the car to avoid this?
Thank you

dpatterson26

iTrader: (6)

It'd hard to suggest what to change when we don't know your current setup. Can you post your current setup and we will go from there.

TC Travis

Can't quote the link (the site says I can't post URL's for some reason so, had to cut it)

Nice to see my review doing the rounds haha!

Its a really nice car, learning every time I drive it


I am annoyed a little bit with VBC at the moment. We basically lost the deal to be the main agents here in the UK. Its currently available to anyone who wants to bring a kit in, so seems like there isn't much being done to support the brand with a decicated supplier.
It feels like there isn't much support avaliable. Apart from EWS (essex winter series), I haven't seen much from the 1 VBC sponsored driver. It would be nice if they can establish a good team here in the UK

Anyway, rant over. I have had the car since February and still trying to perfect setups that work over here. I have seen some good ideas from some of you guys, will try these things out. The 1.1mm hole in the shock cap really intrigues me

Anyone else struggle to get consistent preload across all 4 shocks? After a meeting, they fill with air!

Has anyone experienced this? Different diaphram caps/ Different o rings maybe?

sashimi999

iTrader: (8)

Looks like this is Axle from R1 wurks but mount on VBC drive shaft.

JayL

Have you tired drilling the 1.1mm hole in the cap like we do, and was posted earlier in the thread?

http://www.rctech.net/forum/13192686-post931.html

This works very well

TC Travis

Yea, I read it last night

I'm actually ordering a spare set to drill right now (in case I don't like it haha!)

IIGQ4U

iTrader: (53)

You'll like it.

scoyle

Jamie Booth at SMD is distributing the Wildfire here in the UK.

Roedor

Hello,

Here is my setup, please let me know what can I do for give more "life" to the front tyres.

Thank you

Roedor

here is the file!!!

Gridworks Racing

iTrader: (3)

Raise the front roll center underneath the suspension mounts using 1mm shims.

Fred Hubbard

iTrader: (6)

Roedor your sheet is incomplete. Please tell us what all the missing information is.

Roedor

Thank you Gridworks Racing!!!

It think that was it is missing is:

front droop 5.4
rear droop 4.8
body mazda speed

let me know if you need any more info.

R Doyel

iTrader: (14)

this blew my mind.