humayraykinaon

iTrader: (4)

its been so long I'm behind with all of my updates lol, anyway after I install my HR Bulkhead I was not impressed by it so I went with RPM instead. I don't have the red X3 body anymore and so as the 2nd X3, that was totaled now from getting run over by a 1:1 car. I did manage to hit my marking point 80MPH (84mph) but before the run I make sure everything was sturdy enough so I got HR motor mount, HR slipper clutch Super Duty, Tekno Big Bone and STRC bellcrank.
HR slipper clutch SD


Tekno BB with center bearing carrier

front chassis need some dremel work to clear the drive cup

HR motor mount

my gearing 25T/34T needs a little shaving with my HR motor mount to clear the pinion


STRC bellcrank

humayraykinaon

iTrader: (4)

here's my 2nd X3


here's after got run over (didn't take picture of the body but you get the picture )

humayraykinaon

iTrader: (4)

I now have another PF8 and this is my 4th one and counting lol I do like the X3 a lot but at that time they were out of stock so I got the PF8 instead

humayraykinaon

iTrader: (4)

here's a simple mod that I find it very useful getting rid of that stubborn c-hub play, a E-maxx hinge pins cut to length, works best with aluminum c-hubs.

I added an E-clip at the end just incase the pin back off

humayraykinaon

iTrader: (4)

I now change my Center brace from an XO-1


and my antenna stand off lol

humayraykinaon

iTrader: (4)

here's my second build, its a Backsl4sh RoadRunner