Originally Posted by badboy
Hi. Can you share your setup?
Here is some info about my setup:
Camber is set to the maximum
Medium spring (gold)
And i did run black rubber O-rings under and above the front carbon upper suspension plate.
So far i'm the only one that uses O-rings on the front instead of using alu spacers.
This will give extra flex on the front suspension, but the top suspension plate will come higher then normal. (you can't
use Ride R1 tires with this conversion)
Ride height is set at 5mm
Medium to hard roll damper grease
350 in pitch damper with medium (yellow) spring
Links on the outer hole.
Medium (gold) roll springs
Ride height is also set at 5mm
Tires i have used are 571&575
Hope this helps