Originally Posted by Walitopr
Hi I have a brand New sp F1 and I need dime help.
The height in the front is 10mm and back 8mm. How fixed that problem to Put the CAR in 5mm for run in the carpet.
This is the First CAR in Puerto Rico
Rear....refer to the manual, page 4, step #6 and choose the correct plastic insert, sometime you have to flip the insert up side down to lower the car.
Front...refer to the manual, page 7, step #12. the 2mm spacer was used for the stock FOAM setting (the manual is setup per the foam tires, usually they are smaller then the rubber tires)...when you want to RAISE the arm higher, that will lower the chassis, add 2mm or even 3mm spacer on top of that 2mm and you will SLAM the car down....
Or refer to the manual, page 8, step #14...instead of using the 1mm spacer, add another 2mm spacer and form a 3mm drop.
The front need some time to go thru it...but if you look at my setup several pages back, I was using 2mm shim (total) below the carbon lower plate, then using 3mm shims below the arm (above the carbon lower plate) and this setup will give you around 5mm ride height when using rubber tires.