Put the rack in without any of the ball ends hooked up, don't have the nuts on top on either... pull out one side's bearings (so there's only bearings on one pole) move the rack back and forth, figure out where the tight spot is and shave it down with an exacto knife. Repeat this for the other side of the rack.
When you put it all back together make sure you don't overtighten the nuts on top.. they can introduce alot of tightness too... good luck!
[url=http://www.corallyusa.com/][color=Red]- Corraly USA -[/color][/url]
[url=http://www.corallyusa.com/specializedrc/index.htm/][color=Red]- Specialized R/C -[/color][/url]
[url=http://www.thunderrc.com/eshop/][color=DarkRed]- Team Thunder RC -[/color][/url]
[url=http://www.cfxpaintworks.com/][color=DarkOrange]- CFX Paintworks -[/color][/url]
[COLOR=DarkSlateGray]- Team Ertrachter Factor - [/COLOR]
If my last name were Oxlong, I would name my kid Mike... yup Mike Oxlong
I don't want to pay for my sig, so yawl figure it out...