Hpi Pro4 2005 edition?
#1
Tech Regular
Thread Starter
Hpi Pro4 2005 edition?
anyone heard of this? any news in english?
#2
Re: Hpi Pro4 2005 edition?
Originally posted by Exe
anyone heard of this? any news in english?
anyone heard of this? any news in english?
Ive heard of it but this is the first time ive seen pictures of it seems like they have made some improvements on it
#3
do a search in the Pro 4 thread - it's mentioned and described a couple of pages back.
#4
Tech Regular
Yea Ive heard about it but it just seems to me thats its a regular pro 4 with some hopups like the camberlinks, transponder mount, and the modded top deck other wise it seems just like a regular old pro 4.
Justin
Justin
#7
Tech Champion
iTrader: (9)
Originally posted by R40Victim
I want that motor mount. It'd be alot easier to just thread in the screws a bit, then slide the whole thing in. Is it available separately? Where can I find one like that?
I want that motor mount. It'd be alot easier to just thread in the screws a bit, then slide the whole thing in. Is it available separately? Where can I find one like that?
the piece I really want is the onepiece input shaft and bevel gear.
#8
Btw. Is anyone else that problem. When you install motor back to your Pro4 it is quite difficulty to use sruwdriver when tight those motor scruws, because especially when you try to tight upper motor scruw it is odd angle to make it wright... vs lower
I normally use Hudy scruwdriver to secure at it is tight enogh.
I hope you all understand what i mean
I normally use Hudy scruwdriver to secure at it is tight enogh.
I hope you all understand what i mean
#9
Tech Adept
Get a 2.5mm BALL-END hexwrench, that'll solve your problem.
#10
Originally posted by Erlend
Get a 2.5mm BALL-END hexwrench, that'll solve your problem.
Get a 2.5mm BALL-END hexwrench, that'll solve your problem.
#12
But i don`t still get it, because that rear camberplate is in line when i try to tight that upper motor scruw
#14
Thanks zombie, now i understand that