Core stock motor
#1
Tech Fanatic
Thread Starter
Core stock motor
What's the hot brush and spring set up for these?
Do you gear them differently than a P2K2 or P2K? I have a TC3 geared at 72/28 with a P2K2.
Thanks for any input.
Do you gear them differently than a P2K2 or P2K? I have a TC3 geared at 72/28 with a P2K2.
Thanks for any input.
#2
this question belongs in the stock motor forum. please re-post and inquire there
#3
Tech Fanatic
Thread Starter
Can't find that thread so my questions stand?
Got answers?
Got answers?
#4
Company Representative
iTrader: (14)
I'm using the Axiom version of the motor with their brushes...
Part# 1203
12% Silver with cavity (Serrated)
Checkout:
Axiom Motors Products Page
These things rock...
I will post dyno pulls I have...
7.0V & 120 Watts @ 21A...
as far as gearing on a TC3?
I ran it in a XXX and 78/22 for a small high traction track.
Part# 1203
12% Silver with cavity (Serrated)
Checkout:
Axiom Motors Products Page
These things rock...
I will post dyno pulls I have...
7.0V & 120 Watts @ 21A...
as far as gearing on a TC3?
I ran it in a XXX and 78/22 for a small high traction track.
Last edited by Tres; 07-22-2002 at 12:01 PM.
#5
Ok now, these are just suggestions. I haven't actually tried it out yet but I've been told that this is a good setup.
4499s with purple/red spring pos/neg.
I asked about the purple, thinking it was too stiff, and was told it helps bring the torque out. I've also been told narrowing the brush on the trailing edge only helps with efficiency. I'll report more as soon as I've tried some of these tips.
4499s with purple/red spring pos/neg.
I asked about the purple, thinking it was too stiff, and was told it helps bring the torque out. I've also been told narrowing the brush on the trailing edge only helps with efficiency. I'll report more as soon as I've tried some of these tips.
#6
Regional Moderator
iTrader: (3)
Originally posted by coolrcdad
Can't find that thread so my questions stand?
Got answers?
Can't find that thread so my questions stand?
Got answers?
There is some guys talking about this the rctech-team orion forum...
http://www.rctech.net/forum/showthre...&threadid=6580
Sorry about the cross post, just answering a question!!!
#7
Tech Fanatic
Thread Starter
Thanks.