SerpentCT4S

iTrader: (95)

I am selling my NEW D3 roller!

http://www.rctech.net/forum/r-c-item...sakura-d3.html

PM me if interested!

pickled

yay got my SP reventon pro installed flashed with drift firmware set forward/brake/reverse and now I have reverse awesome

Exita

Thats good news

eunique

iTrader: (3)

Nice! I'm loving and missing mine. Been gone for a few days and for a total of 2weeks....I am fiending to practice with mine...miss drifting a lot even nthough I am on vacation right now. Baaaad addiction....it's bad hen you can't wait to get back from vacation so you can practice drifting.

I ordered my alloy MST hubs and CVDs (MST and R31s)

Also need to start working on my Zero S CS also.

Tommy R

iTrader: (21)

I decided to order a Pandora RC Nissan body. I would like to order some wheels at the same time, but am not sure what offsets to get....or if they're different front to rear. Can anyone recommend a good offset that will work well with this body and the D3?

This is the body I'll get. Pandora says it's 196mm(?):


This is the look I'm after (basically wheel flush with the fender lip):


Thanks in advance!
Tommy

mrjfang

pickled's reply on fitting a 190mm shell

from the previous page...

kei office s15

iTrader: (17)

check my d3 on fb. check my steering angle.
greetings from trece martires city cavite philippines!


https://www.facebook.com/photo.php?f...type=1&theater

eunique

iTrader: (3)

Nice! Looks wider angle than stock...which CVDs are u using to get wider angle?

bennychen

Hi guys, my steering seems too little free play, is this normal? Please refer to the link of video below, Thanks

youtu.be/PQ_T9kM7xis

mrjfang

droop screws in the way. either A) take them out and stop using them or B) move them to the other set of holes closer to the front

bennychen

You mean the screw fixed at the wheel arm? But that was the screw should be used showing in the instruction manual, or I should replace with shorter screw?

mrjfang

its really up to you. I'm pretty sure the front holes are for future sway bars, but they arent used for anything else and I currently have my droop screws up front

bennychen

Noted, will try it tonight, Thank you

kotar

i have a pandora NSX and i am running +4mm and some +6mm rims and both are very flush, the +6mm i think is almost popping look, so i would imagine its very similar to that pandora one-via

pickled

I don't know my pandora 370Z is 205mm I run 10mm on the front and 12mm on the rear and 6mm wheel adapters. you need to measure the width at the top of the wheel arches.