Yokomo MR4TC-BD
#2191
Tech Elite
iTrader: (2)
Originally Posted by Randy Caster
I had that race bagged if I didnt get hit on the straight with about 20 seconds to go. I BQ'ed, missed the A main by 1 qualpoint in the tiebreaker round... it sucked.
Randy congrats on your performance. I saw your 23 lap run and I thought that would put you on top for the A main. I guess you had some trouble in the earlier runs cause i didn't see too many 23 lappers in open mod.
#2192
R/C Tech Elite Member
iTrader: (47)
Originally Posted by jwf_frani
Randy congrats on your performance. I saw your 23 lap run and I thought that would put you on top for the A main. I guess you had some trouble in the earlier runs cause i didn't see too many 23 lappers in open mod.
#2199
Tech Regular
iTrader: (4)
Bearing Buster
Holy Crap!!!
Is it just me or does this car go through bearings!!
I just inspected my hub bearings only to find that 5 of the 8 bearings were frozen stiff!!!
I only raced the car 2 qualifiars on a groomed track!!!
This must be a record. What am I doing wrong???
Is it just me or does this car go through bearings!!
I just inspected my hub bearings only to find that 5 of the 8 bearings were frozen stiff!!!
I only raced the car 2 qualifiars on a groomed track!!!
This must be a record. What am I doing wrong???
#2200
Tech Elite
Originally Posted by Randy Caster
Anyone know who makes aluminum servo horns for airtronics servos in either black anodized, or yokomo blue color?
#2201
R/C Tech Elite Member
iTrader: (47)
Originally Posted by letitroll
Holy Crap!!!
Is it just me or does this car go through bearings!!
I just inspected my hub bearings only to find that 5 of the 8 bearings were frozen stiff!!!
I only raced the car 2 qualifiars on a groomed track!!!
This must be a record. What am I doing wrong???
Is it just me or does this car go through bearings!!
I just inspected my hub bearings only to find that 5 of the 8 bearings were frozen stiff!!!
I only raced the car 2 qualifiars on a groomed track!!!
This must be a record. What am I doing wrong???
#2202
Tech Elite
iTrader: (9)
Originally Posted by Randy Caster
Anyone know who makes aluminum servo horns for airtronics servos in either black anodized, or yokomo blue color?
Which servo are you using.
93457 60 or the ultra in servo the 757?
I have had great results from my KO's so far...
I finally get to test the LCG tomorrow and the BD but a get to test the Dart system form Nimble also...Oh I will be at Hot Rods most of the day. I will let you all know how things fair.
Stephen <><
#2204
Tech Champion
iTrader: (31)
Hey Shookie, I've been a little 'lazy' & sick lately so I haven't even touched the LCG yet. As far as the Rubberneck bumper goes, do as Randy says and shave it. My bumpers look great... Yoke, Pro4, RDX.
I finally finished up the electronics layout, take a peek
Until next time... -JB
I finally finished up the electronics layout, take a peek
Until next time... -JB
Last edited by JayBee; 09-12-2008 at 09:29 PM.