Hot Bodies Cyclone
Tech Adept
iTrader: (1)
I just picked up a used Cyclone (S I think) and the one thing I noticed it that the spur gear was only 81 teeth. I tried to put an 84 teeth that came with it and the gears are rubbing on the bottom cassis. Can anyone help me. This is my first on road car. oh yeah the cassis is plastic so pretty sure it is some form of Cyclone S.
I just picked up a used Cyclone (S I think) and the one thing I noticed it that the spur gear was only 81 teeth. I tried to put an 84 teeth that came with it and the gears are rubbing on the bottom cassis. Can anyone help me. This is my first on road car. oh yeah the cassis is plastic so pretty sure it is some form of Cyclone S.
Tech Elite
iTrader: (115)
Sorry to hijack (?) the thread, but I sold my cyclone, and I have a shell: LTC-R that is brand new and custom painted, It was mounted as a display body and never run. May be of use to someone here. PM if interested, thanks.
http://www.rctech.net/forum/9361346-post1.html
http://www.rctech.net/forum/9361346-post1.html
Last edited by nf_ekt; 07-08-2011 at 07:39 AM. Reason: add FS link
Tech Adept
iTrader: (1)
Thanks. I will give that a try.
Tech Master
iTrader: (41)
Is this Pro4 part:HPI MIP CVD Alum Purple RS4 Pro 4 (2) HPI80827
the same as #61088 MIP CVDS CYCLONE WORLD CHAMP EDITION PURPLE???
thanks
idbdoug
the same as #61088 MIP CVDS CYCLONE WORLD CHAMP EDITION PURPLE???
thanks
idbdoug
Tech Champion
iTrader: (13)
The MIP CVDs that came with the pro 4 are 46mm. They might bottom out in the front diff or spool since the car was designed to be used with 44mm. I don't know for sure because I have never tried this.
-Korey
-Korey
Tech Elite
iTrader: (61)
if u need axle parts shoot me a PM i got LOADS OF THEM!
Tech Master
iTrader: (41)
ive been reading up on the offset motor mount but I dont know where to buy it from. Does anyone run it ?
Tech Master
iTrader: (41)
I run the #67696 Aluminum Rear Hub Carrier (1 Degree/Right/Left) and i lost the set screw that goes into the bottom. Does anybody know what the correct hpi part number for the set screw so i can get a replacement???
Thanks
idbdoug
Thanks
idbdoug
Tech Elite
iTrader: (61)
Hope this helps.
Tech Master
iTrader: (41)
thanks
idbdoug
Tech Elite
iTrader: (61)
Ok here is one for you guys. I got a Cyclone tc with a 108 spur gear. The Website says the brushless motor mount fits a 110 spur. I have the Brushless mount on my TC and the Spur hangs out the bottom of the chassie. how does the 110 even Fit?
Tech Fanatic
iTrader: (1)
With the 2.5mm chassis and the BL motor mount, I have been using 64p 116 spur gears for more then 4 years, it is not hanging out below the chassis at all.