Hot Bodies Cyclone
At the IIC this year, Andy was using one car for both mod and 13.5 so i guess the setup would work fine for 17.5 as it was excellent for 13.5. Is there huge difference between 13.5 and 17.5?? i have never tried 17.5 so may be i'm wrong...
Hope it helps
Hope it helps
What electronics was Barry using ?
Thanks.
Thanks.
Tech Regular
The difference is the 13.5 is faster on the straight, but I have seen 17.5 do less lap time than 13.5 in the right hands.
How about throwing some of the more recent setups on the HB site? The last published setup sheet on the HB page is from way back at the 2008 Reedy race!
Any chance of some Hot Bodies TC tips videos coming out? Something similar to the recent Groskamp Tamiya videos on RedRC of him setting up and building his 416. That would be most excellent.
Any chance of some Hot Bodies TC tips videos coming out? Something similar to the recent Groskamp Tamiya videos on RedRC of him setting up and building his 416. That would be most excellent.
Tech Fanatic
Tech Elite
iTrader: (118)
Tech Regular
iTrader: (16)
Tech Champion
iTrader: (13)
For the front, I usually start with the 1.5 deg block. This gives 1.5 deg of arm sweep. When you run less arm sweep (0 or 1 deg suspension mount), this will make the car enter the corner more aggressive, but be smoother through the middle and exit of the corner. The more sweep you run (2, 2.5, or 3 deg) will give slightly smoother steering on entry, but have more steering through the middle and exit of the corner.
Hope that helps!
-Korey
I'm sorry but I still have some questions to lead: what are the "2.0deg blocks" and the tires are the Solaris? and if that strength?
Thanks in advance
No problem George!
I need to add info that option parts Barry had on his cars.
- DCJ Drive Shafts (used in front)
- Low friction Shock Bodies
- Aluminum Diff Out drives
- HPI Shock Springs (gold up front/Silver in rear)
- HB's ceramic diff balls
- 4mm Hex hubs (used in front)
I need to add info that option parts Barry had on his cars.
- DCJ Drive Shafts (used in front)
- Low friction Shock Bodies
- Aluminum Diff Out drives
- HPI Shock Springs (gold up front/Silver in rear)
- HB's ceramic diff balls
- 4mm Hex hubs (used in front)
Yes thanks
Question related to that.
What is the difference (or not) between the toe-in given by the suspension mount, from the turnbuckles and the C-hubs ??
Question related to that.
What is the difference (or not) between the toe-in given by the suspension mount, from the turnbuckles and the C-hubs ??
Tech Regular
Is there a setup for Barry 13.5 car? if yes please post.
Tech Elite
iTrader: (3)
i have alot of hotbodies stuff for sale pm me if ur looking for something