Hot Bodies Cyclone
thanks you KOREY
could anyone post their setup for a medium traction track and for low traction track outdoor with rubber thanks you
Tech Rookie
thanks again!
if possible fot a tight and technichal track thanks
i have the same problem when you go to the outside hole on the rear up rights. what you do is shave off the top of the ball cup just gotta keep an eye on the amount of dirt that gets in there as it will wear out the ball end quicker
the track is like this :
http://www.wlrc.co.uk/
as you can see the straight of the track is curved but normaly its straight not curved only the picture is showing it curved
http://www.wlrc.co.uk/
as you can see the straight of the track is curved but normaly its straight not curved only the picture is showing it curved
the track is like this :
http://www.wlrc.co.uk/
as you can see the straight of the track is curved but normaly its straight not curved only the picture is showing it curved
http://www.wlrc.co.uk/
as you can see the straight of the track is curved but normaly its straight not curved only the picture is showing it curved
Tech Champion
iTrader: (32)
This is what happens when you're not happy with the last time you raced.....LOL New plastic everywhere It will be ready for electronic installation tomorrow if I don't get it all done today. My son's football practice zapps all the energy out of me I must be getting old!!! Scotty and I have some work to do against some of the guys that are Tamiya loyal on Sunday. Should be a great fun day......Well back to car rebuilding.
Pics are the front end on the left side of set up board, rear on the right, and chassis in the middle.
Pics are the front end on the left side of set up board, rear on the right, and chassis in the middle.