Hot Bodies Cyclone
Tech Elite
iTrader: (32)
What brand spur is the 81?
What are the rules for this RCGT class?
Robinson Racing. You can only use 2 screws to hold the spur though.
Tech Elite
iTrader: (152)
Anyone have experience with run a rear spool, front diff and a center one-way? I mainly use my cyclone for drifting, and I used to have this set up on my Yokomo SD, the center one-way gives the car the "e-brake" effect to initiate or prolong drifts and keeping the front diff helps with on power turning. Just wondering if it works with the cyclone (I figure it will), since my spool will be here soon and haven't tried it yet.
Tech Elite
iTrader: (32)
This will work for drifting,not for Onroad racing.I had the same setup on my ta05,and I imagine it would work equally as well if not a little better with the cyclone.
Tech Master
iTrader: (19)
You had a TA05? Wow...I never knew that...want to purchase a RDX??? LOL I might have 2 or 4 laying around still....LOL
Tech Elite
iTrader: (32)
Tech Elite
iTrader: (63)
Anyone had a problem with thier WCE Cyclone Swaybar holders (the bit that clips onto the A-Arm is tight/Binding. I have all original HB Parts and they are not the tc arms.
?????
?????
So does anyone have any input on what to run in he front for asphalt? Diff, one way or spool? Again this is for RCGT.
If you decide to go with a spool. The HB Ver. 3 spool is the best spool out there for the Cyclone. It's very durable. And it's much lighter than the newer TC Spool/One-way combo.
You mean the ball cups? If they seem tight you can use a lighter to heat the ball cups then pop them on the arms. This will stretch the ball cups out slightly allowing them to move more freely on the arm mounts.
Tech Champion
iTrader: (32)
Tech Champion
iTrader: (13)
Cool. Thanks for the input.