Equalizing
#61
Then, I am getting the integy discharge trays by the end of this week. I will put the cells on in the morning and then finish them up on the ics.......I hope to get some good mah's in....
#62
Tech Apprentice
iTrader: (6)
If you are charging with an old Millinium, you must be charging in the NiCd linear profile. You can adjust the delta peak down if your packs are getting too hot. I have had good luck and duribility charging at 5a with 48 dp. They come off warm take 4200-4300 after comming off the tray...