Problem with LRP SXX TC Spec V2
02-07-2012, 01:03 PM
#16
Hehehe! 
My name is Panos.
See you tomorrow then!
Thanks a lot!!!!
My name is Panos.
See you tomorrow then!
Thanks a lot!!!!
02-16-2012, 09:24 PM
#17
Tech Adept
dear all, pls help on this issue.
recently, i just brought the LRP firware update pc bridge link cable and trying to update my ESC to V2, but i facing the fail connection on it, pls help me on this issue.
1st of all, i plug in the LRP USB Bridge - Speedo Firmware Update + PC-Link into the computer, and it auto install the driver from window XP, after that the blue led at the bridge light up, after that i plug in the sensored cable from ESC to the bridge, and start up the LRP firware update tools v2.0.4 for pc and click connect, it pop out a instruction asking me to off the on/off switch, and unplug the batterry, after i click ok on the instruction, it start to search and take time around 15-20 seconds, and i saw the bridge light up the yellow/orange led together with the blue led at the same time, meanwhile, ESC also light up BLUE (not red, suppose to be red according to the user manual) LED, and after that it show can't establish the connection. pls help on this issue. thanks.
recently, i just brought the LRP firware update pc bridge link cable and trying to update my ESC to V2, but i facing the fail connection on it, pls help me on this issue.
1st of all, i plug in the LRP USB Bridge - Speedo Firmware Update + PC-Link into the computer, and it auto install the driver from window XP, after that the blue led at the bridge light up, after that i plug in the sensored cable from ESC to the bridge, and start up the LRP firware update tools v2.0.4 for pc and click connect, it pop out a instruction asking me to off the on/off switch, and unplug the batterry, after i click ok on the instruction, it start to search and take time around 15-20 seconds, and i saw the bridge light up the yellow/orange led together with the blue led at the same time, meanwhile, ESC also light up BLUE (not red, suppose to be red according to the user manual) LED, and after that it show can't establish the connection. pls help on this issue. thanks.
02-17-2012, 05:41 AM
#18
I have the same problem with my nosram....
02-17-2012, 01:13 PM
#20
FWIW when I've seen this it has been solved with a capacitor on the receiver, or swapping out the servo. In two cases it had something to do with the Savox servo... in a pinch maybe try a cap before sending back.
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
