gfx
 

ok i know there are other gfx threads, but i couldn't find one that this would fit into.

i can't seem to figure out how to change the number of cells being charged. when wanting to make changes to a profile, do i scroll thru all the different modes, make mode changes then save if all to the profile? i'm having a hard time finding this info in the instructions. and is there somewhere i can find what all the pre-exisiting profiles are, and for what purpose each is meant?

Change the number of cells with in the Discharge mode and save that in the profile you want.


It's doesn't care how many cells are being charged(4, 6 etc...).
It does care during discharge which you set the cut-off per cell.(.9)

Checkout:

http://www.balakracing.com/turbo35gfx.htm

Some good info there.