Tamiya TA05 Mini 4WD
#4
#5
Tech Master
iTrader: (3)
[QUOTE=C&B RC;9851720]http://kentech.blogs.se/2011/10/12/t...four-12004985/
From the photos, it appears the this uses a 380 size motor and a shorty battery pack. I'm out!!!!!!!!
From the photos, it appears the this uses a 380 size motor and a shorty battery pack. I'm out!!!!!!!!
#9
Tech Elite
iTrader: (7)
Join Date: Jun 2002
Location: Melbourne, Australia. Home of rc-mini.net
Posts: 3,549
Trader Rating: 7 (100%+)
For those people entertaining the thought of splashing out their cash on an M Four, with the idea that 'Oh I'm sure you can fit a 540 in there somehow...'
Take note of these pictures of our car. There is literally no possible way to put a 540 motor into this car without machining new bulkheads and a new upper deck. That's what you'll need to do..
Take note of these pictures of our car. There is literally no possible way to put a 540 motor into this car without machining new bulkheads and a new upper deck. That's what you'll need to do..
#10
Tech Rookie
axle snapped
centre drive axle snapped whilst using brushless motor,
part number is 13454826 B30, does anyone know where i can get this?
part number is 13454826 B30, does anyone know where i can get this?
#11
Tech Regular
#12
Tech Regular
Anyone know which Stabilizer can be used in the Front of this? I just finished putting TA05 aluminum bulkheads front and rear. The rear M05 stabilizer fit on the rear no problem. But the front one seems a bit short and I would have to change from split blocks to a solid 1XA block or the ball connector on the suspension arm will hit the blocks.
I'm loving this car http://tamiyatorg.blogspot.com/2012/11/ta05-m-four.html
I'm loving this car http://tamiyatorg.blogspot.com/2012/11/ta05-m-four.html
#13
Tech Initiate
Hey torg, I just posted on you blog, but not sure if you're more active here.
What size pinion are you using with your 13.5T motor, and where are you getting Tamiya's MOD .06 pinions from, or any pinions that will fit? 48P def will not work unless you use maybe HPI's spur gear from the Cup Racer.
[QUOTE=torg;11506361]Anyone know which Stabilizer can be used in the Front of this? I just finished putting TA05 aluminum bulkheads front and rear. The rear M05 stabilizer fit on the rear no problem. But the front one seems a bit short and I would have to change from split blocks to a solid 1XA block or the ball connector on the suspension arm will hit the blocks.
I'm loving this car
What size pinion are you using with your 13.5T motor, and where are you getting Tamiya's MOD .06 pinions from, or any pinions that will fit? 48P def will not work unless you use maybe HPI's spur gear from the Cup Racer.
[QUOTE=torg;11506361]Anyone know which Stabilizer can be used in the Front of this? I just finished putting TA05 aluminum bulkheads front and rear. The rear M05 stabilizer fit on the rear no problem. But the front one seems a bit short and I would have to change from split blocks to a solid 1XA block or the ball connector on the suspension arm will hit the blocks.
I'm loving this car