A. Rhodes : Thanks! what do you mean 14 peak detect outside w/ heat sink? how will i set that?
I meant racing outside, warmer ambient temps., and using a MM Heatsink to help keep the packs from getting too hot and tripping the temp cut off.
You can use the temp feature in the CTXC and directly wire the heatsink fans in so it starts and stops at certain temps, or just run it off a power supply.
__________________
Retired from RC....
Quantum - St. Croix - Bass Pro Shops - XPS - Rapala
Look me up on Xbox Live - FTADOT - more than happy to mop up the floor w/ you in COD4....
A. Rhodes : Ok, i got it! thanks! what is the difference using 21 delta peak settings compared to 14 of Big B? does it give more punch and power?
I run IB4200's right now but I will be trying some EP4200's soon, you can expect them to peak up to 10% higher than 4200 (4620). As for the higher peak detection setting I don't think so, but it is a more sensitive peak setting and therfore could result in a faulse peak. I have heard you can do up to 3mv per cell, which works out to 18 on a 6cell pack, I havent tried it that high yet. The setup I gave you is straight from a Much More Team Driver.
__________________
Xray 007 Euro, Much More Racing Andy Moore Edition Pit Equipment, Futaba 3pks 2.4ghz Fasst System, Novak, Team Brood Motors
Big B : i got your point, and i guess setting lower delta peak will give the batts longer life. actually i have a new sets of EP4200 right now. i'll try the settings you a gave me and same as the settings of A. Rhodes. i'll check which is better for EP4200. thanks!
A. Rhodes : Ok, i got it! thanks! what is the difference using 21 delta peak settings compared to 14 of Big B? does it give more punch and power?
Increasing the delta peak will still result in more power. However, since you are able to adjust the delta peak by much finer increments (1mV as opposed to 10mV with most other chargers), you can do so more safely with the Cell Master.
__________________
Retired from RC....
Quantum - St. Croix - Bass Pro Shops - XPS - Rapala
Look me up on Xbox Live - FTADOT - more than happy to mop up the floor w/ you in COD4....
Hi Guys, just got the charger and was wondering if someone could help me. looking to charger Tamiya 1600 NiCd and Sanyo 2400 NiCd. What seetings should i use for these batts. I will be running the 1600 with mabuchi silver cans and 2400 with sports tuned. Thanks guys.
I just bought the Andy Moore edition, i found out it doesn't charge Li-po's even though it said it did. Its still NIB factoryu sealed, $165 shipped.
you need to "turn on" that feature. hold down the "right arrow" until it goes into set up mode. from there, scroll until you see the lipo function. turn it on from there.
Hi Guys, just got the charger and was wondering if someone could help me. looking to charger Tamiya 1600 NiCd and Sanyo 2400 NiCd. What seetings should i use for these batts. I will be running the 1600 with mabuchi silver cans and 2400 with sports tuned. Thanks guys.
hold down the "right arrow" until it goes into set up mode. from there, scroll until you see the lipo function. turn it on from there.
Similar Threads