Fred Hubbard

iTrader: (6)

You confused me because you initially referred to all 4 positions (FF,FR, RF,RR) Yeah I saw the selection option for the rear but since the reason of going to the single blocks for the FR and RF was to strengthen the chassis I'm a bit skeptical that they would release an option that would circumvent that so I have to wonder if maybe that's an error on the sheet But maybe we will find out at some point

RCTVLIVE

iTrader: (11)

We are assembling ours now. It has the same fit and finish we all expect out of Xray. The kit is going together without any snags and we will have a full review, tested on our new indoor carpet track! Another winner from Xray!

Jeff

Fred Hubbard

iTrader: (6)

Not cool Jeff, not cool...you just had to rub it in a bit huh j/k I wouldn't expect anything less!!!

CraigM

iTrader: (34)

It looks to include the 2pc suspension bridge for the front judging by the kit setup. Other than that the kit setup is the same as '11 just with the gear diff and shocks in one hole.

I think I'll just get the top deck and the knuckles to start with

rx7ttlm

iTrader: (30)

You may want to mill the bulkheads, which chassis are you running?

nashrcracer

iTrader: (1)

are the bulkheads changed from the 2011 need to know if I am good getting a T3r to change out the alumninum other then the new clamps that I already took easyoff to the clamps to get the orange out.

CraigM

iTrader: (34)

11 kit chassis. The 12 one looks the same shape, just with the holes to mount the servo sideways

The clamps aren't lower on the '12 are they? I always thought it was a bit dumb to make them so high in the first place

rx7ttlm

iTrader: (30)

Mine are machined down about 1.5mm iirc. Not sure if they changed on production kits. I was thinking they were lower but don't know for sure, maybe EA knows.

Fred Hubbard

iTrader: (6)

Not sure if you knew or not but the knuckles are already an existing part number they just swapped out the mediums for hards in this model.


Yeah I was hoping that they would have redesigned those in this kit to be lower but from the pic it looks like they are the same as when first releashed. I agree lowering them is definetely a must do.

jubilee

iTrader: (37)

U.S. price?

bucketboy

Stupid question but why?

Bb

yokemad

on 90% of the setups people using around 1mm+ shims on upper clamps Can I ask in which conditions we need to go Lower than L1-L2 Height?
Many Thanx

syndr0me

iTrader: (32)

What makes the chassis different? Mounting holes for the servo?

Fred Hubbard

iTrader: (6)

Yep and the chassis is narrower.

Fred Hubbard

iTrader: (6)

Even more granular roll center adjustment.