MrRolla

iTrader: (30)

#302069, they will crack if you overtighten the screw into them

Fred Hubbard

iTrader: (6)

In addition multiply the C value by 5.71 (3.0 x 5.71 = 17.13lbs).

rdlkgliders

iTrader: (21)

Thx.
I thought they were aluminum and overtightened

rdlkgliders

iTrader: (21)

I am headed out with my son for his first day with the t3 12, and yes I will be getting in my fair share of laps also.

Below is a pic of his 3 generations of xrays

Matt W

Hi,

I run the xray t3 12 mainly on mid sized carpet tracks. Ive always run 13.5 boosted and am now switching over to 17.5 blinky. Roughly how many teeth in pinions do i need to go up by in comparison, any ideas?

MikeXray

iTrader: (73)

Aim for a 4.0 FDR to start, depending on your track size, you may need to go lower. (I typically have a 92/44)

FiremanKen

hi did you use any shims and if so which size on the servo?

Ken

locked

iTrader: (1)

No shims. There's some from the servo saver to the steering link, but the servo itself is not shimmed. I do use the rubber grommets on all the ears though, to help prevent tweak. Allows for a little bit of flex.

roger999

iTrader: (13)

guys, any ideas what to do to have same toe in on rear left and right wheels? right hand side is 3 but left hand side is about 2.8..? i pushed the alu holders against tightening direction but still is not right.. First was 2.5 but now i could do it until 2.8 but still have no 3... the car is brand new of course....

haywood

iTrader: (49)

Buy the one piece suspension mount for the front of the rear.

roger999

iTrader: (13)

Yeah but probably will be less flexible after i mount it...?

moggy12

just shim the 2.8 side until you get 3 toe in i have had 2 xray t3 and never had both sides the same from using same shims

haywood

iTrader: (49)

Yes... You will loose a little rear grip I've been told.

roger999

iTrader: (13)

But after that does the lenght will change? probably will be little different left and right.

kinga

iTrader: (15)

+1, I have had a t3r, t3 2011 and now t3 2012, and all have had different toe left to right.
I find 1.75mm of shims on the left, and 1.5mm shims on the right gives equal toe in of 3 degrees. Not sure why.
Using the one peice holder at the front of the rear will reduce rear flex and traction