Xray T3 2012
#1516
#1517
XRAY t3 2012
I'm selling a X-ray t3 2012 roller used 1 time at the track
$400
Car is brand new
Pm me.
$400
Car is brand new
Pm me.
#1518
#1519
Tech Adept
Pins coming out
Hi,
Appart from using the top racing axle pin covers is there a way of stopping the driveshaft pins slowly sliding out? Im using the xray pins with the flat and also using threadlock, Im usually very gd at building driveshafts but i am having a little issue with the front ones, any ideas?
Appart from using the top racing axle pin covers is there a way of stopping the driveshaft pins slowly sliding out? Im using the xray pins with the flat and also using threadlock, Im usually very gd at building driveshafts but i am having a little issue with the front ones, any ideas?
#1520
Hi,
Appart from using the top racing axle pin covers is there a way of stopping the driveshaft pins slowly sliding out? Im using the xray pins with the flat and also using threadlock, Im usually very gd at building driveshafts but i am having a little issue with the front ones, any ideas?
Appart from using the top racing axle pin covers is there a way of stopping the driveshaft pins slowly sliding out? Im using the xray pins with the flat and also using threadlock, Im usually very gd at building driveshafts but i am having a little issue with the front ones, any ideas?
___________
Leighton Lederer
{R/C Plus Salem Oregon}
#1521
its hard to me to find the shaft with the flat spot, what i do is I use silicone paste and cover the hole with it. It works but need to re-check after few run, and last longer if use high quality one
#1522
Skiddins
#1523
Can u use 52mm ecs shafts with the multi diff when its locked as a spool?
Last edited by theatriks; 02-21-2012 at 10:25 AM.
#1530