This is a mind boggler....
11-18-2004, 03:39 PM
#1
This is a mind boggler....
How can a massage in a kr-302f reciever into a tc3 that has a novak dually esc. I kind of dont want to put it on top of the servo, but it just might have to get put there 
If it does go there, i know i should put some wire insulation around the antenna thats going to have to be exposed to get to the antenna mast holder, but should i do anything else? O ya, i know it says not to put the crystal closest to the chassis, but if i were to put some doublesided tape around it, would i be able to put it with the crystal closest to the chassis? this is the only way i can get the reciever to fit in between the esc and the servo without it being on top of the servo. thanks in advance.
If it does go there, i know i should put some wire insulation around the antenna thats going to have to be exposed to get to the antenna mast holder, but should i do anything else? O ya, i know it says not to put the crystal closest to the chassis, but if i were to put some doublesided tape around it, would i be able to put it with the crystal closest to the chassis? this is the only way i can get the reciever to fit in between the esc and the servo without it being on top of the servo. thanks in advance.
Last edited by onebeatuptc3; 11-18-2004 at 03:45 PM.
11-19-2004, 08:18 AM
#2
Registered User
iTrader: (2)
Join Date: Jun 2004
Location: ROAR HAD ME BANNED FROM RC TECH.
Posts: 2,025
Trader Rating: 2 (100%+)
Can you mount the rx on end?
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
