TT_Vert

iTrader: (72)

From what I see they should be but I just want to make sure i'm not missing something here. Also aside from mocking up the 4 deg blocks, is there a marking I'm missing that identifies Left to Right?



Thanks
Dave

TT_Vert

iTrader: (72)

Anyone know?

Dave

TT_Vert

iTrader: (72)

Surely someone must know.??

MikeXray

iTrader: (73)

I can't see why they wouldn't be, curious as to why you'd run 0 dg though?

wtcc

iTrader: (2)

I never had 0° blocks, but the geometry of the blocks is symetrical and just the drill hole is defining the angle of the block. I once installed one 4° block on the wrong side and had no problems driving the car (just the times were slower). So the 0° blocks are interchangeable!

TT_Vert

iTrader: (72)

I did the same thing and have my 4 deg backwards which is why I now mark my blocks L/R. Which is why I was asking this question lol.

Dave

olly986

There is a little mark L and R on top external (facing front) on each block normally, but not sure if it is there on 0 degree ones, nerver used these, 4 and 6 ok but 0 never