kit pistons - 60 wt Losi oil - 60lb spring - 2 o-rings - middle hole on tower - camber link in lowest position - 4 degree caster blocks - arms flat on chassis - low roll center - 1mm up travel from ride height (4mm) - no sway bars - wheel base in middle - 1 degree arm sweep - 1.5 neg camber - downstops set 1mm before chassis hits bottom - Parma Cyan
kit pistons - 40 wt. Losi oil - 25lb spring - 1 o-ring - out on tower and out on arm - camber link inside on hub and inside middle on tower - 1 degree rear toe - 0 degree off set hubs - wheel base in middle - 2mm up travel from ride height (4.25mm) - downstops set 1mm before chassis hits bottom - Parma Magenta - 1.5 neg camber - sway bar if more steering is needed - low roll center raised .030
I think this is everything. I am doing this from memory while sitting at work
This should be a good starting point..