this little pin wont stay in *pics*
#2
Tech Champion
your setscrew that holds the pin from moving might be stripped out....try new hubs, or putting a coat of ca in the threads of the hub
#3
that did it ,thanks!
#4
Tech Champion
no problem, good luck!!
#5
Tech Adept
Also, file a flat spot int he pin where the set screw hits it. Even if the set screew loosens up it wont slide past the set screw.
#6
From the pics it looks like a Losi car. If it is you can always put the small gold E-clips on each end to make sure it will not slide out.
Brant
Brant
#7
its a tc3 but thanks for the tips!