Originally posted by TC3
Which springs can be used on the r2? will the tc3 springs work?
does the r2 weight less than 1500g (race ready) ?
@JDM, u said: the r2 has 1)Very minimal Torque steer and 2)Low maintanance
what does this mean? (my english is not the best)
and i need a setup for an outdoor asphalt track, traction: medium-high.
What springs do I use... HPI
depending on what electronics you have but on average.. my lightest Barracuda is 1470g race ready..and my heaviest is 1530g
Low maintainance.... = Eazy to work on and very little up keep
You need a medium-high traction set up .
here you go
Hpi Pink27mm springs
1.5deg - neg Camber.
High Roll center upper link on C-hub & camber link on inner position.
upper shock position out most hole
lower shock position on outer most hole
4mm ride height
HPI pink27mm springs
2~2.5 deg toe in
1deg neg camber
Low roll center, lower position on rear hub and camber link on inner most position
upper shock position 2nd most hole from the out side
lower shock position on outer most position
5mm ride height
Bodies' Dodge Stratus 2.0 or 300M
Sorex 28~32 with HPI Red or Orange Inserts...
Hope this is a start for you...or any of you guys that need a good base to start from