Barracuda from Alex racing
#706
Re: Re: Re: Re: Here's some R2 Pic's that I found ...
Originally posted by Tsubasa Sakai
Yeah,I got what you mean.Also do you think it is difficult to screw the lower screw which holding the motor??
Since it is blocked by the a-arm.
Yeah,I got what you mean.Also do you think it is difficult to screw the lower screw which holding the motor??
Since it is blocked by the a-arm.
#707
Tech Champion
iTrader: (31)
lower screw for motor mount....
I Really found the best tool that you can use to get the lower screw off .. and you don't have to take any thing off to get to it either ......A HUDY Hex driver with the head that is kind of rounded makes life really easy especially since I now use PAL short arms on all my "Cuda's"...
But even when I used the Square Hard nylon arms it was much simpler
But even when I used the Square Hard nylon arms it was much simpler
#709
waddup
how much for a square motor mount with shaft holder for speedway pal car
#710
Tech Master
Re: Re: Re: Re: Re: Here's some R2 Pic's that I found ...
Originally posted by fai
Hmmm... My solution is to first unscrew the upper nut of the rear left damper... Then pull the A-arm upper a little bit!
Hmmm... My solution is to first unscrew the upper nut of the rear left damper... Then pull the A-arm upper a little bit!
JDM_DOHC_SiR: Thanks.I will try that Hudy driver later.
#711
Tech Master
Re: waddup
Originally posted by dynoman007
how much for a square motor mount with shaft holder for speedway pal car
how much for a square motor mount with shaft holder for speedway pal car
#712
okie
how much tsu ????
#713
Tech Master
motor mount
The marked price of Pal is 9800yen.Square one is 7800yen.
#716
pic of it
how about a pic dave ????
#718
bulky
looks like that thing could use a lil diet but it does hold the shaft so it is better than the one on my pal car atm .......lol
thx dave
thx dave
#719
Tech Champion
iTrader: (31)
Re: bulky
Originally posted by dynoman007
looks like that thing could use a lil diet but it does hold the shaft so it is better than the one on my pal car atm .......lol
thx dave
looks like that thing could use a lil diet but it does hold the shaft so it is better than the one on my pal car atm .......lol
thx dave
It is a bit bulky...but for the amount of weight that I add to the motor side anyways with the normal Cuda Chassis it looks like it would make the balance more even..
but then again the square mount is the lightest compared to the stock one
-Dave