Speedmerchant Rev.4
#1292
No news I dont think yet. Bruce has been very busy with the twins and remodeling. Hopefully something soon.
#1293
Tech Adept
BL Installation
Anyone have any experience installing and/or running a BL system in a Rev4.5? I looked a bit for pictures on this thread but didn't see any. Wondering if there are any issues fitting the motor and wires into the pod (or anywhere else). If it matters, I'm envisioning using the Novak GTB Spread Spectrum 4 Cell speedo and the Novak 10.5 motor. Thanks.
Andy
Andy
#1294
#1295
Tech Adept
#1296
Tech Champion
iTrader: (3)
Join Date: Mar 2003
Location: Peoples Republic of Northern Virginia
Posts: 5,682
Trader Rating: 3 (100%+)
BTW Townsend is better than Luney-burg... The town is taxing the crap out of home owners...
#1297
Tech Master
iTrader: (144)
Doe anyone know the best place to get parts for the 4.5? I bought a NIB 4.5 off rctech and when I went to put it together one of the screw holes for the rear pod non motor mount side had tap broke off in it(it was still in factory bags) I called Bruce and got a call back that very day but was not at my phone.I e mailed him as he requested and have called several times nothing yet (Been about a week) I want to get the part so I can get it together and race it. Thanks
#1298
Tech Champion
iTrader: (3)
Join Date: Mar 2003
Location: Peoples Republic of Northern Virginia
Posts: 5,682
Trader Rating: 3 (100%+)
Doe anyone know the best place to get parts for the 4.5? I bought a NIB 4.5 off rctech and when I went to put it together one of the screw holes for the rear pod non motor mount side had tap broke off in it(it was still in factory bags) I called Bruce and got a call back that very day but was not at my phone.I e mailed him as he requested and have called several times nothing yet (Been about a week) I want to get the part so I can get it together and race it. Thanks
http://www.hobbyetc.com/shopby/brand...breviation=smr
#1300
The 4.5 uses IRS conversion motor plates, you can get a set directly from IRS.
http://www.teamirsrc.com/
part # IRS1164
http://www.teamirsrc.com/
part # IRS1164
#1301
Did you try to drill the screw out of the pod?
#1303
R/C Tech Founder
Anybody have any tips on getting in touch with Speedmerchant? We've been trying to restock parts for the Rev 4 and 4.5 but so far haven't been able to reach them by email or phone after months of trying.
I'm ready to dispatch carrier pigeons, but I just don't know where to point them.
I'm ready to dispatch carrier pigeons, but I just don't know where to point them.
#1304
Anybody have any tips on getting in touch with Speedmerchant? We've been trying to restock parts for the Rev 4 and 4.5 but so far haven't been able to reach them by email or phone after months of trying.
I'm ready to dispatch carrier pigeons, but I just don't know where to point them.
I'm ready to dispatch carrier pigeons, but I just don't know where to point them.