Brad.R

iTrader: (25)

I had some problems with my duo 2 17.5 motor and took it apart to go threw it and a washer was busted inside, how many washers or spacers should be on the rear of the rotor against the sensor board? Also is it just the one big spacer in the front or am I missing something. There is alot of slack when I put the motor back and I dont want to try and run it like that. Thanks

darrenoakley

The shims/washers are there to place the rotor in the optimum position in the stator, so i think most motors will be different mate. To be honest a small amount of play you will find in most motors. I am sure your not the first person this had happened to.