esc connector replacement
#1
Registered User
Thread Starter
esc connector replacement
The wires from the esc to the reciever were bad and causing my car to glitch, so I cut off the connector, so I could cut the bad part of the wire off and reconnect it, but I can't get the wire out of the little metal clips in the connector. Is there any place I can buy a new connector that doesn't already have wire in it? The esc is a GM V12.
Thanks
Thanks
#2
Tech Elite
iTrader: (22)
Just cut off the wire really close to the ESC and re-wire a fresh wire with a new connecter already on it to that cut piece. You could do that or you could open up your ESC and sergically replace the wire on the board. It all depends on how you feel about your soldering skills.
#3
Tech Master
regarding the connector you can buy any similar type of connector to your local electronics store... mafiaracers also gives you an idea if you want to make a clean connection then solder it to the board of the esc so that there will be no solder connection from the wires... depends to you...
#4
If you're having trouble fixing your old wires you can also get new wires and connectors from www.servocity.com
#6
Registered User
Thread Starter
Thanks alot guys.
#7
Registered User
Thread Starter
Just ordered some connectors and pins.