Ciao to all,
yday evening finally i uploaded the a30 firmware on my vtx10r, then i procedeed with radio calibration and started with progauge to setup my profile, and here begun my issue
, as default the esc is on profile 1, i tried to change it to profile 7 with progauge but no way, once progauge connected it shows profile 1 and if i push the up or down arrows it shift on setup mode no way to change profile number
. The only way to change profile is to enter in program mode directly from the esc then change the profile switch off and then on and connect progauge to edit the profile. Is it a new change on the firmware or is it a real issue?
tnks for yr support